Home & Leisure

/

ArcaMax

Here's How: Proper Method To Lay Decking Wood

James Dulley on

Dear James: I am building a large new L-shaped deck. I am not sure about how to position and attach the decking boards because of the L shape. Do you have any tips? -- Greg S.

Dear Greg: Fitting and attaching the decking boards is usually the easiest part of a deck building project. An L-shaped deck makes it a bit more complicated, but still doable. Locating the posts and the joists properly is particularly important for a strong, stable deck with no sagging.

Once you have the posts and joists installed, protect them from rot and insect damage prior to laying the decking. Even though the lumber for the joists should be pressure-treated, the pressure treatment may not have fully penetrated the wood. This is often true with lumber made from fir. The nails or screws, which attach the deck boards, slightly split the top of the joists and this allows moisture to enter deep into the wood.

In order to protect the joists from this potential moisture damage, cut plastic film into long, narrow strips. The strips should be wide enough to cover the top of the joists. Three inches wide is a good target. Staple these strips over the top of the joists before installing the decking boards.

For the best appearance, select the proper length decking boards for the specific deck. If the deck is short enough so that one decking board can span it, use single boards that are at least one inch longer than the deck. This will provide some overhang for a smooth trim-cut edge.

In your case, with a large deck, you will need several boards to span the entire length. Don't just buy the longest boards possible and then use shorter pieces to finish the span. Select a variety of board lengths to create a random pattern of joints and don't make any of them too short. Just use your judgment as to what combination of lengths looks good.

You have two options of where to start laying the boards: either at the house wall or the deck rim. Starting at the rim is easier because you do not have to plan the location of each board. If there is space for only a narrow board at the house, it will be supported well and won't look bad.

 

On the other hand, if you start at the house, plan the spacing of the boards. You don't want to attach all the boards and then find you have room for only a very narrow board at the outer rim. This board will be difficult to attach securely, and it will look bad.

At the rim edge, snap a chalk line across the joists at the location of the edge of the first board plus 1/4 inch. This extra quarter inch allows you to see the line when you are laying the first row of boards. Attach them at every fifth joist and then check to make sure everything is straight and even.

When you are satisfied, screw them in with two screws to every joist. Space the screws the same distance from each edge of each board for a symmetric fastener pattern. Use spacer blocks for uniform spacing between the boards.

========

Send your questions to Here's How, 6906 Royalgreen Dr., Cincinnati, Ohio, 45244 or visit www.dulley.com. To find out more about James Dulley and read features by other Creators Syndicate writers and cartoonists, visit the Creators Syndicate website at www.creators.com.

Copyright 2022 Creators Syndicate Inc.

 

Comments

blog comments powered by Disqus
 

Comics

Bizarro John Darkow Jimmy Margulies John Cole Pat Bagley Kirk Walters