Home & Leisure

/

ArcaMax

Ask the Builder: How to hang a fancy wall sink with no visible support

By Tim Carter, Tribune Content Agency on

Q: I need your help solving a perplexing conundrum. I love all things old and have purchased a salvaged antique marble stone corner sink that I want to use as a powder-room lavatory.

It already has a drain hole, so that's not the issue. The faucet needs to be in the wall, and I can handle that as well. My problem is I want the sink to appear as if it's floating in the air with no visible means of support.

The sink is really heavy, as it weighs close to 70 pounds. What can be done to achieve my goal, and what other tips do you have to make sure this goes well? Are there any hidden problems you might know of I need to avoid? --Sharon F., Key Largo, Fla.

A: Years ago I used to purchase quite a few salvaged building materials for some of my projects. I was so lucky to have a specialty business near me that foraged for one-of-a-kind building fixtures, doors, mantles, sinks and so forth in buildings slated for demolition. They had so many things you simply couldn't believe it. One day I found a stunning solid walnut fireplace mantle I incorporated into the last home I built for my family.

Installing an antique sink shouldn't be a problem at all. When deciding to purchase one, you usually just have to make sure the holes for the drain and faucet will work with modern parts. Even if a hole is too small, it can usually be enlarged with minimal effort.

The other thing you need to do is to be sure the sink is going to fit really well in the space where it will end up. Recently, I had to install an antique sink corner sink in my daughter's new home. I uncrated it to inspect it and to create a template because I wanted to see if the sink itself was square and would fit nicely in the corner of her powder room.

 

Guess what? The old sink was about 1.5 inches out of square in just 30 inches! That's a huge discrepancy. A rookie might have assumed the sink was square and been in for a surprise once the sink was lifted in place. I made a template of the sink using scrap cardboard and then padded out the wall studs to account for the out-of-square sink. After the drywall was installed the sink fit perfectly. All I had to do was squirt a small amount of caulking to seal the gap between the sink and the wall.

My daughter wanted the sink to float on the wall. I was able to locate a company online that sold these very heavy steel brackets that screw to the sides of wall studs. A 1/4-inch thick steel plate extends out into the room that the sink can rest upon.

I had to install two of these, one extending out from each wall in the corner. The challenge was to make sure the brackets didn't block the drain hole, didn't extend too far out (and thus be visible), and didn't touch one another. Believe me, this exercise took some planning!

If you do have a conflict where the brackets don't fit perfectly, you may have to install an extra wall stud, move one, or cut off a small amount of one bracket to resolve the issue. In any case, you'll be able to figure it out. The 1/4-inch thickness of the steel plate is a non-issue. Even sitting on the toilet looking at the sink, you can't really see the steel and you wonder how in the world the sink is not crashing to the ground.

...continued

swipe to next page
(c)2020 TIM CARTER DISTRIBUTED BY TRIBUNE CONTENT AGENCY, LLC.
 

Comments

blog comments powered by Disqus
 

Social Connections

Comics

Andy Marlette Jerry King Cartoons Fort Knox Dog Eat Doug Shoe Pearls Before Swine